MKS elite 300, Руководство по эксплуатации

Страница: 37 / 55

System Installation
elite
TM
33
2.11 System Check
Before the elite
TM
generator can be used, it is imperative that the following
procedure be followed to ensure optimal and safe operation. Make sure
that:
1. The AC line cord is connected to the AC mains. Verify that AC input power
is correct. (See section 2.9 for more information on AC Power
Requirements.) Inspect the AC power connector and cable before use –
replace if damaged.
2. The RS ‐ 232 serial cable, if used, is connected to the 9 ‐ pin D ‐ type serial
connector on the rear panel.
3. The Analog Interface Cable, if used, is connected to the analog I/O
connector. (See section 2.4 for more information on the analog
interface.)
4. The RF output cable is connected to the RF Output connector on the rear
panel. Ensure that the RF cable and connectors are in good condition –
replace if damaged.
5. The RF output cover is on.
RF Output Cover
RF Output Cover
Figure 2.11