MKS elite 300, Руководство по эксплуатации

Страница: 22 / 55

System Installation
18 elite
TM
2.2 Installation Requirements
2.2.1 elite
TM
Airflow Requirements
A minimum space of 75 mm (3”) should be allowed front, rear and sides for
ventilation. Approximately 160 CFM (4530 liters/min) of airflow is required.
2.2.2 Power Requirements
The AC Input Ratings of the elite
TM
Generator are indicated on a label
attached to its back panel. Those nominal ratings are as follows:
100 VAC – 264VAC, 50/60Hz, 15A, Single Phase
Upstream Disconnect Device
Safety listing of model elite
TM
generator requires that its
installation include an upstream current ‐ limiting disconnect
device rated 50 ‐ 60 Hz, 250V ~ minimum, and no more than
20A. The upstream disconnect device must be located
within sight of the elite
TM
unit, must remain user ‐ accessible
at all times, and must be labeled so as to indicate the
equipment it disconnects. During installation, removal,
and/or servicing of the elite
TM
unit, place the upstream
disconnect device into its off (open) position, and follow
lock and tag (lock ‐ out / tag ‐ out) procedures to control
hazardous energy (reference appropriate regional
regulations and requirements). No circuit should be
connected or wired when electricity is present.
For safety compliance, the elite
TM
must be powered with a connection that
has a hardware ‐ based EMO circuit.