26
MK-Scarifier SeTUP
Pre-start inspection
The pre-start inspection should be performed before beginning any job. If Cutting Discs are worn, or
are missing carbide inserts (carbide cutting discs only), replace the discs before starting work.
•
DO NOT rotate Scarifier to rest on handlebar. Engine damage will result.
•
The carbide tips on carbide cutting discs are approximately 1/4-inch in length. When
the carbide disc is worn to the end of the carbide tip, the tip may fall out leaving a small
hole.
NOTe:
(A)
Inspect the Cutting Discs for
excessive wear and missing
tips.
(B)
Inspect Engine for leaks.
(C)
Inspect the Scarifier for
general damage and/or loose
hardware.
(D)
Verify the Height Adjust-
ing Wheel moves freely
and moves up and down
smoothly.
(E)
Verify the Scarifier rolls freely.
(F)
Check for proper oil level
(See Engine Manual).
(G)
Check for proper fuel level
(See Engine Manual).
(H)
Check Air Filter for cleanliness
(See Engine Manual).
