Miyachi Amada ISQ20 Series, Руководство по эксплуатации

Страница: 32 / 63

ISQ20
Connections
76609605EN-ISQ20-V1.2.docx 32/63
4.3.4 X4: Valves
DSUB 15 - socket
Pin I/O Function Note
X4.1
O15 VV1 Valve triggering 1 +24 V Function depends on control mode, see
chap. 5.3.1
X4.2
VV1_GND 0 V ext. (ref. to 24 V)
X4.3
VV1_PE Protective earth
X4.4
O16 VV2 Valve triggering 2, +24 V Function depends on control mode, see
chap. 5.3.1
X4.5
VV2_GND 0 V ext. (ref. to 24 V)
X4.6
VV2_PE Protective earth
X4.7
O17 VV3 Valve triggering 3, +24 V Function depends on control mode, see
chap. 5.3.1
X4.8
VV3_GND 0 V ext. (ref. to 24 V)
X4.9
VV3_PE Protective earth
X4.10
O18 VV4 Valve triggering 4, +24 V Function depends on control mode, see
chap. 5.3.1
X4.11
VV4_GND 0 V ext. (ref. to 24 V)
X4.12
VV4_PE Protective earth
X4.13
O19 VV5 Valve triggering 5, +24 V The valve output can be chronologically
programmed.
On current changeover the valve comes
after the first current program and remains
until end of second hold time.
X4.14
VV5_GND 0 V ext. (ref. to 24 V)
X4.15
VV5_PE Protective earth
4.3.5 X5: Start
Binder 6 + PE - socket
Pin I/O Function Note
X5.1
+24 V External supply voltage
X5.2
I15 Start
head 1+2
min. 35 mA at 24 V Unit has to be “ready” before start is set
(i.e. Quick Stop is set and unit is in a
welding menu).
A program has to be selected in case of
external program selection (not program
“0”).
For a sequential program (e. g. lower
stroke cylinder), the cylinder initiators
have to be in basic position.
This input is used for automatic sequential
run in twin-head mode (parallel with
current changeover or consecutive
sequence):
head 1 –head 2 - FK – end.
Setting this input starts welding.
X5.3
I16 Start
head 1
min. 35 mA at 24 V Start signal for head 1 in twin head mode.
X5.4
I17 Start
head 2
min. 35 mA at 24 V Start signal for head 2 in twin head mode.
X5.5
0 V ext. (ref. to 24 V)
X5.PE
PE Protective earth