Miyachi Amada ISQ20 Series, Руководство по эксплуатации

Страница: 29 / 63

ISQ20
Connections
76609605EN-ISQ20-V1.2.docx 29/63
Pin I/O Function Note
X2.28
O28 Out of limits head 2 100 mA at 24 V The actual welding value (depending on the
control mode current /voltage / power) is
checked for deviations from rated value. If
deviation is greater than specified by
maximum and minimum value (limits and
curves), this output is set.
Opposite to X2.5 this output is only available
if stepping contact (FK) is active.
It hast to be read out prior to breaking
(opening) the Start.
X2.29
O29 Out of limits
pulse 1 100 mA at 24 V The actual value of first welding pulse
(depending on the control mode current
/voltage / power) is checked for deviations
from rated value. If deviation is greater than
specified by maximum and minimum value,
this output is set.
Special case for
pneumatic head
and activated
(internal)
pressure/force
measuring:
Error
pressure/force
head 1
X2.30
O30 Out of limits
pulse 2 100 mA at 24 V The actual value of second welding pulse
(depending on the control mode current
/voltage / power) is checked for deviations
from rated value. If deviation is greater than
specified by maximum and minimum value,
this output is set.
Special case for
pneumatic head
and activated
(internal)
pressure/force
measuring:
Error
pressure/force
head 2
X2.31
S3
Open:
24 V external
Closed:
24 V internal
(max. 1.5 A)
Output power supply; depending on switch
position of S3 (see chap. 4.1).
X2.32
X2.33
S3
Input power supply; depending on switch
position of S3 (see chap. 4.1).
X2.34
X2.35
GND
0 V external
(refer to 24 V)
Reference ground
X2.36
X2.37
PE Protective earth