Mitsubishi S4Q, Руководство пользователя

Страница: 114 / 174

114 / 174 Service Manual Mitsubishi SQ-Series diesel engines
Version 08/2004
ENGLISH
STARTER ELECTRICAL SYSTEM
ELECTRICAL SYSTEM
27 STARTER
27.1 Inspection before disassembly
(inspection of assembly)
If an abnormality is found, disassemble and repair.
1. Pinion gap
1) Connect the positive (+) cable of the battery to
terminal S of the starter and the negative (-)
cable to the starter body to extend the pinion.
2) Lightly press the tip of the extended pinion
shaft with a finger, and measure the distance
of the shaft movement.
3) If the measured value is not within a range of
0.1 to 2.5 mm [0.0039 to 0.0984 in.], increase
or decrease the number of packings at the
magnetic switch section for adjustment. An
increase of packings results in a decrease of
the pinion gap.
2. No-load test
1) As shown in the diagram, connect an
ammeter, voltmeter, revolution indicator and
battery.
2) Turning on the switch should extend the pinion
and operate the starter at the specified speed
or faster.
If the current or rotating speed does not
conform to the standard value, disassemble
the starter for inspection and repair.
Figure 181 Inspection of pinion gap
+ -
12V
S
Lightly press
the tip
0.1 to 2.5 mm
[0.0039 to
0.0984 in.]
24V (option)
Starter
Battery
CAUTION
Do not supply electricity for more than 10 continuous
seconds.
Figure 182 No-load test
- +
12V
V
A
Switch
Revolution
indicator
24V (option)
Starter
Battery
Ammeter
Item
Standard
value
Starter model M008T70371
Nominal output V-kW 12-2.0
No-load
characteristics
Terminal voltage V 11
Current A 130 or lower
Rotation speed rpm 3600 or higher