Mitsubishi LGH-100RX5-E, Руководство пользователя

Страница: 32 / 123

Function settings
PZ-52SF-E or remote
controller not used
(Function selec-
tion switch)
SW5-1: ON
—32—
2
Interlock mode
Lossnay can set the following 4 types of interlock modes for the start/stop signal from the external device.
3
Delay operation
This function delays the starting of Lossnay for 30 minutes with respect to the start signal from the external
device (and for 10 to 60 minutes when using PZ-41SLB-E). When using remote controllers other than PZ-
41SLB-E, LED1 on the Lossnay circuit board will light during delay operation. Also, when using PZ-60DR-E
and PZ-41SLB-E, there will be a display of the delay time.
*1: Display of LCD when setting is by PZ-60DR-E remote controller
1
(Factory
setting)
SW5-7: OFF
SW5-8: OFF
(Factory setting) The start/stop condition
will be reversed each
time the pulse signal is
input. ON/OFF
interlock
(Remote
controller
last touch
operation
permitted)
Interlock
mode
PZ-41SLB-E
(Interlock
mode)
PZ-60DR-E
(Remote controller
function selection)*1
Pulse signal input
Lossnay will start with
the operation signal of
the external device, and
Lossnay will stop with
the stop signal.
Other than pulse signal
input
Interlock mode
setting selection
“onoF”
(Factory setting)
SW5-7: ON
SW5-8: OFF 2 Lossnay will start when
the pulse signal is
input.
Stopping is by remote
controller. ON interlock Lossnay will start with
the start signal of the
external device.
Stopping is by remote
controller. Interlock mode
setting
“on”
SW5-7: OFF
SW5-8: ON 3 Lossnay will stop when
the pulse signal is input.
Starting is by remote
controller. OFF inter-
lock Lossnay will stop with
the stop signal of the
external device.
Starting is by remote
control. Interlock mode
setting
“oFF”
SW5-7: ON
SW5-8: ON 4 Same as ON/OFF inter-
locked. External
input priority
ON/OFF
interlock Same as ON/OFF inter-
locked.
Note that during opera-
tion that started with a
signal from the external
device, stopping by
remote controller will
not be possible. Interlock mode
setting
“oUT”
Setting Method
PZ-41SLB-E
(Delay starting time)
PZ-60DR-E
(Remote controller func-
tion selection)
PZ-52SF-E or remote
controller not used
(Function selection switch)
Setting Method
Delay operation setting
“oFF”
(Factory setting) Normal operation 0 minutes
(Factory setting) SW5-1: OFF
(Factory setting)
Delay operation setting
“on” Delay operation 10 to 60 minutes (in 10-
minute units)
Note that delay operation will be disabled under the following condition
When the start signal from the external device is a pulse signal.
When the system is interlocked with Mr. Slim or City Multi indoor units set to the fan operation mode.
When the system is restarted within 2 hours of Lossnay stop.
When the interlock mode is set to “OFF Interlock”.