Mitsubishi LGH-100RX5-E, Руководство пользователя

Страница: 26 / 123

SW2-3: ON
(Refer to page
38)
—26—
When PZ-60DR-E will not be used in a system of
multiple Lossnay units, set the function selection
switches on the Lossnay circuit board for each
unit.
The fan speed display of the remote controller,
and the system controller will be the same for
either Extra High or High.
2 Fan speed control by function setting
The following fan speed control can be set with PZ-60DR-E or the function selection switch (SW2) on the
Lossnay circuit board.
Function
PZ-60DR-E
(Remote controller
function selection)
PZ-60DR-E Not Used
(Function selec-
tion switch)
Supply fan
speed setting
Extra High SH: L
High H:
L
Exhaust fan
speed setting
Extra High SH: L
High H:
L
(Refer to page
41)
Air supply SW2-9
: ON
Exhaust SW2-10
: ON
(Refer to page
38)
Supply fan
speed setting
Multiple ventila-
tion :
L
Exhaust fan
speed setting
Multiple ventila-
tion :
L
(Refer to page
41)
Air supply SW2-4
: ON
Exhaust SW2-5
: ON
(Refer to page
38)
This switches the settable fan speed from the remote controller
and the system controller. Set this when there is a need for
large air volume, or when there is a long duct line.
When set to High fan speed, High/Low fan speed can be set,
and when set to Extra High fan speed, Extra High/Low fan
speed can be set. Extra High
/High
Fan speed
selection
This switches the settable fan speed from the remote controller
and the system controller to a fixed Low fan speed. The sup-
ply/exhaust balance is adjusted to suit the usage environment
or the place of installation. Multi venti-
lation
mode
Power supply/
exhaust when
operation starts :
ON
(Refer to page
41)
During the first 30 minutes of operation, operation will be at
High (Extra High) fan speed. This is used when rapid ventila-
tion is desired at the time of starting operation.
After 30 minutes have elapsed since starting operation, or
when the fan speed set from the remote controller or the sys-
tem controller has been changed to something other than High
fan speed, power ventilation will be cancelled and the system
will follow the fan speed set by the remote controller or system
controller. Power
supply/
exhaust
mode
(When
operation
starts )
Details
Setting Method
Display
Multiple
units
When PZ-60DR-E will not be used in a system of
multiple Lossnay units, set the function selection
switches on the Lossnay circuit board for each
unit.
When both supply and exhaust are set to the multi
ventilation mode, due to operation restrictions PZ-
60DR-E cannot be switched to a setting other
than Low/Extra Low fan speed. Other remote con-
trollers and system controllers can change the fan
speed display; however, the fan will remain fixed
at Low fan speed.
Operation
Multiple
units
When PZ-60DR-E will not be used in a system of
multiple Lossnay units, set the function selection
switches on the Lossnay circuit board for each
unit.
During power ventilation, PZ-60DR-E will display
“POWER VENT START”. Other remote controllers
and system controllers will display the set fan
speed, even during power supply exhaust opera-
tion.
Display
Multiple
units