Mitsubishi FX3G-14MR/ES, Руководство по установке

Страница: 4 / 24

FX3G INSTALLATION MANUAL
4
1.3 INCLUDED ITEMS
Check if the following product and items are included in the package:
MAIN UNITS
FX3G-14M_ ~ FX3G-60M_
Product 1 unit
Dust proof protection sheet 1 sheet
Manuals [English version] 1 manual each
1.4 FRONT PANEL
n
FACTORY DEFAULT CONFIGURATION (STANDARD)
[1] Peripheral device connecting connector cover. The peripheral
device connector, variable analog potentiometers and RUN/STOP
switch are located under this cover.
[2] Terminal names. The signal names for power supply, input and
output terminals are shown.
[3] Top cover (S). (40 points, 60 points type only) Mount the expansion
board under this cover.
[4] Top cover. Mount the expansion board, display module and battery
under this cover.
[5] Terminal block covers. The covers can be opened for wiring. Keep
the covers closed while the PLC is running (the unit power is on).
[6] Input display LEDs (red). When an input terminal (X000 or more)
is turned on, the corresponding LED lights.
[7] Operation status display LEDs. The operation status of the PLC
can be checked with the LEDs. The LEDs turn off, light and flash
according to the following table. For details on the operation status,
refer to Section 7.
LED Name
Display
Color
Description
POW Green On while power is on the PLC.
RUN Green On while the PLC is running.
ERR Red
Flashing when a program error occurs.
Lights when a CPU error occurs.
ALM Red
Lights when the battery voltage drops.
(When the optional battery is used)
[8] Output display LEDs (red). When an output terminal (Y000 or
more) is turned on, the corresponding LED lights.
[9] Model name (abbreviation). The model name of the main unit is
indicated. Check the nameplate on the right side for the model name.
[10] DIN rail mounting hooks. The main unit can be installed on
DIN46277 rail (35mm (1.38") wide).
[11] The year and month of production. The year and month of
production of the main unit is indicated.
n
WHEN THE TOP COVERS ARE OPEN
[1] Peripheral device connecting connector (USB). Connect a
programming tool (PC) to program a sequence.
[2] Peripheral device connecting connector (RS-422). Connect a
programming tool to program a sequence.
[3] RUN/STOP switch. To stop writing (batch) of the sequence
program or operation, set the switch to STOP (slide it downward). To
start operation (run the machine), set it to RUN (slide it upward).
[4] Variable analog potentiometers. Two variable analog
potentiometers are built in. Upper side : VR1, Lower side : VR2
[5] Optional equipment connector 1. Connect the expansion board to
the connector.
[6] Optional equipment connector 2 (40 points, 60 points type
only). Connect the expansion board and display module to the
connector.
[7] Battery connector. Connect the optional battery to the connector.
[8] Battery holder. This holder accommodates the optional battery.
[9] Optional equipment connecting screw holes 2 (2 places)
(40 points, 60 points type only). These holes are designed to secure
the expansion board with screws.
[10] Optional equipment connecting screw holes 1 (2 places).
These holes are designed to secure the expansion board with screws.
[6]
[2]
[1]
[5]
[4] [3]
[8]
[10]
[9]
[11]
[7]
[9] [10]
[8]
[7]
[6] [5] [4]
[2]
[3]
[1]