Mitsubishi MOTORS Outlander 2018, Руководство пользователя

Страница: 223 / 441

Rear-view camera (if so equipped)
5-142 Features and controls
5
2. Hold down the multi information display
switch for 10 seconds or more. (A beep is
heard.)
(Although the reset execution starts at
holding down the switch for 3 seconds,
keep holding down the switch continu-
ously.)
3. The valid tire ID set is changed, and the
number of the tire pressure monitoring
system (TPMS) SET indicator is changed.
N00533001233
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions.

This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
N00546201301
When the selector lever is in the “R”
(REVERSE) position with the ignition switch
in the “ON” position, or the operation mode
is put in ON, the rear-view image will be dis-
played on the screen of the DISPLAY
AUDIO or the Smartphone Link Display
Audio.
When the selector lever is shifted out of the
“R” (REVERSE) position, the rear-view
image will go off.
NOTE
 Each time this procedure is done, the tire ID
set is changed. (1 - 2 - 1 - 2 …)
 The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
General information
CAUTION

Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Rear-view camera
(if so
equipped)
WARNING
 Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
 The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
 The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
BK0249100US.book 142 ページ ２０１７年５月１０日 水曜日 午前８時４９分