Mitsubishi MOTORS Outlander 2018, Руководство пользователя

Страница: 312 / 441

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-231
5
N00554301040
HomeLink
®
Wireless Control System is a
registered trademark of Gentex Corporation.
HomeLink
®
provides a convenient way to
replace up to 3 hand-held radio-frequency
(RF) transmitters used to activate devices
such as gate operators, garage door openers,
entry door locks, security systems, even home
lighting. Additional HomeLink
®
information
can be found at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the toll-free HomeLink
®
-Hotline at 1-
800-355-3515.
N00584600029
 Some garage door openers manufactured
after 1995 have “rolling code protection”.
To program a garage door opener
equipped with “rolling code protection”;
you will need to access the garage door
opener motor to press the motor’s “Learn”
or “Smart” buttons. For convenience, use
a ladder and another person to assist you.
 It is recommended that a new battery be
placed in the hand-held transmitter of the
device being programmed to HomeLink
®
for quicker training and accurate trans-
mission of the radio-frequency signal.
HomeLink
®
Wireless Con-
trol System
(if so equipped)
WARNING
 Do not use HomeLink
®
with any garage
door opener that lacks safety stop and
reverse features as required by U.S. Fed-
eral Regulations. A garage door opener
which cannot detect an object in the path
of a closing garage door and then auto-
matically stop and reverse, does not meet
current U.S. Federal Regulations. Using a
garage door opener without these features
increases the risk of serious injury or
death.
 During programming, your garage door
or gate may open or close. Make sure that
people and objects are clear of the garage
door or gate that you are programming.
NOTE
 Once HomeLink
®
is programmed, retain the
original transmitter for future programming
procedures (for example, new vehicle pur-
chases). Upon sale of the vehicle, the pro-
grammed HomeLink
®
buttons should be
erased for security purposes. Refer to
“Cleaning the programmed information” on
page 5-235.
 You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See “Cleaning the programmed information”
on page 5-235 or “Reprogramming a single
HomeLink
®
button” on page 5-235.
WARNING
1- HomeLink
®
button 1
2- HomeLink
®
button 2
3- HomeLink ®
button 3
Before programming Home-
Link
®
BK0249100US.book 231 ページ ２０１７年５月１０日 水曜日 午前８時４９分