Mitsubishi Electric PURY-P200, Руководство по обслуживанию

Страница: 68 / 224

- 65 -
(A) Deleting group registration information
<When completed normally>
- If there is a transmission error, registration is not deleted and
the display shown below appears.
In this case, repeat the operations above.
<When an error occurs>
When deletion was completed
normally, is displayed at the
unit type display.
If a deletion error occurred,
is displayed at the unit type
display. In this case, repeat the
operations described above.
(B) When deleting interlocked registration
is displayed at the room temperature display.
is displayed at the room temperature display.
To return to the normal state, go to step
0
.
(Alternate display)
(4) (A) Group registration and (B) Interlock registration of another group using an arbitrary remote controller
(A) Group registration and (B) Interlock registration of another group can be performed using an arbitrary remote controller.
For a description of the operation procedure, see (B) Interlock registration of section [2] 1. Group setting/interlocking setting.
Set the address No. as shown below.
(A) When performing group registration
Interlocked unit address ... Remote controller address No.
Indoor unit address ........... Indoor unit address No. you want to control with the remote controller
(B) When performing interlock registration
Interlocked unit address ... LOSSNAY address No.
Indoor unit address ........... Indoor unit address No. which is interlocked with LOSSNAY
” “
” “
”
“
” “
” “
2. Remote controller functions selection
In the remote controller function selection mode, three functions can be selected and changed. Select and change these functions, as required.
For the operating instructions refer to (6) How to select the remote controller functions of 3 How to Operate in Instruction Book.
(A) Operation mode display selection mode ( AUTO mode heating/cooling display selection)
When the AUTO mode was selected with the remote controller, the indoor unit is judged from the room temperature and heating or cooling is
performed automatically. In this case, AUTO COOLING or AUTO HEATING is displayed at the remote controller. However, only AUTO without
COOLING or HEATING can also be displayed.
(B) Room temperature display selection mode (Room temperature display/no display selection)
Normally, the intake air temperature is displayed at the remote controller. However, no display can also be selected.
(C) Set temperature range limit mode
Ordinarily, the set temperature can be freely set over the 19 ˚C to 30˚C range for cooling and dry and the 17˚C to 28˚C range for heating. However ,
for cooling and dry, the lower limit temperature and for heating, the upper limit temperature can be limited to a preset temperature. If the set
temperature range is made higher for cooling and dry and is set lower for heating by this method, excessive cooling and heating can be prevented
and energy can be saved.
CAUTION
When the normal set temperature adjustment range was changed using a remote controller connected to a simultaneous
cooling/heating air condition with an AUTO mode, the AUTO mode cannot be selected with the [Mode selection] button.
”
“
” ” ” ” “
” “
“ “ “ ” “
” “
” “ ” “
PAR-F27MEA
ON/OFF
FILTER
CHECK TEST
TEMP.
TIMER SET
CLOCK ON OFF
1
2
3
[Remote controller function selection mode transition]
[Remote controller OFF window display]
1
2
3
:Press and hold down the [CHECK] and
[Mode selection] buttons at the same
time for 2 seconds
:[TEMP. ( )] button
:[TEMP. ( )] button
OFF window
Operation mode display selection mode
Room temperature display selection mode
Set temperature adjustment range limit mode (cool/dry)
Set temperature adjustment range limit mode (heat)
Remote controller function selection modes
2 3
4
1 1 →
→
3 2
→
→
3 2
→
→
3 2 →
→