69
ON/OFF
˚
C
˚
C
ERROR CODE
ON/OFF
CALL:XXXX
XXX:XXX
Error Code
●
If only the error code is blinking (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the
system. In this case, you should note down the error code and then call your dealer or servicer for advice.
* If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen.
(You can set this up under Function Selection of remote controller. For information, refer to 4.5.)
●
If the ON lamp and error code are both blinking: This means that the air conditioner is out of order and operation has been
stopped (and cannot resume). Take note of the indicated unit number and error code, then switch off the power to the air con-
ditioner and call your dealer or servicer.
ON/OFF
ERROR CODE
If you have entered contact number to be called in the event of a problem,
the screen displays this number. (You can set this up under Function
Selection of remote controller. For information, refer to 4.5.)
ON lamp
(Blinking)
Indoor Unit’s
Refrigerant Address
Error Code
Indoor Unit No.
Alternating Display
4.4.2. Error Codes indication
4.5. Function Selection
Various remote controller functions are selectable in the remote controller function selection mode. Change setting when needed.
Item 1
Item 2
Item 3
1. Change language
(“CHANGE LANGUAGE”)
Language setting to display
• Some European languages are selectable.
2. Function limit
(“FUNCTION SELECTION”)
(1) Operation function limit setting (operation lock)
(“LOCKING FUNCTION”)
• To invalidate some functions.
(2) Use of operation mode setting (“SELECT
MODE”)
• Setting the use or non-use of operation mode
(3) Temperature range limit setting (“LIMIT TEMP
FUNCTION”)
• Setting the temperature adjustable range (maximum,
minimum)
3. Mode selection
(“MODE SELECTION”)
(1) Remote controller main/sub setting
(“CONTROLLER MAIN/SUB”)
•
Selecting main or sub remote controller
*
When 2 remote controllers are connected to 1
group, 1 controller must be set to sub.
(2) Use of clock setting (“CLOCK”)
• To select the use or non-use of clock function
(3) Timer function setting (“TIMER MODE”)
• To select the timer type
(4) Contact number setting in case of fault
(“CALL.”)
• Contact number display in case of error
• To select the telephone number
(5) Temperature offset setting(“TEMP OFFSET
FUNCTION”)
• To select the use or non-use of the water tempera-
ture offset funstion
4. Display change
(“DISP MODE SETTING”)
(1) Temperature display °C/°F setting (“TEMP
MODE °C/°F”)
• To select the temperature unit (°C or °F) to display
(2) Water temperature display setting(“WATER
TEMP. DISP. SELECT”)
•
To select the use or non-use of the display of “actual
fl ow water temperature”
When the Check button is pressed:
Содержание Mr.SERVICE PUHZ-HRP100VHA2
Страница 95: ...95 ...
