TM_i-BX(-N)_NC05_00_06_20_EN
MEHITS S.p.A.
●
TECHNICAL MANUAL
Version NC05 - Translation of the Original Instructions
13
DHW management information
[Only visible with the Installer or Service password - only for i-BX-N and if the domestic hot water function has been enabled]
○,1
Temperature difference between
○,6
and
○,5
○,5
Unit input water temperature
○,2
Domestic water temperature setpoint
○,6
DHW storage tank temperature
○,3
DHW pump status
-
Off
-
Manual
-
On
-
Sniffer
-
En.boost - In COOL + DHW (both DHW and system priority) or HEAT + DHW (DHW
priority), if there is system request and no DHW request the "En.boost” message
appears
-
Act.boost -> Same condition as above, in addition to others regarding parameters
0208-0209-0210-0611-0612, but in this case, in addition to the appearance of the
message, the DHW pump starts at maximum speed
-
Sn.Freeze
–
Antifreeze Sniffer
-
Max T - Forcing of overboost due to setpoint not reached
-
Max set - Temperature very far from the setpoint
○,7
Unit output water temperature
○,4
Temperature difference
○,8
Storage tank heater status
Storage tank heater NOT
active
Storage tank heater not
active
Inertial storage tank information
[Only visible with the Installer or Service password - only for i-BX-N and if the BT9 probe has been enabled - parameter 0314 = YES]
○,1
Water temperature setpoint
○,3
Storage tank internal water temperature
○,2
Unit output water temperature
○,4
Unit input water temperature
Inverter Power+/compressor information
[Menu only accessible with the Service password. By pressing ENTER and using the UP and DOWN keys, it is possible to access all the information managed by the Power+ driver]
