Mitsubishi Electric EMU4-CNT-MB, Руководство пользователя

Страница: 41 / 136

40
Changing the Control Type
Operation of Control Unit Engineering Tool
Write the network information into the
control unit.
Refer to
7.10.1 Writing Network
Information .
If an extension unit is connected to the parent
terminal, finish the connection and the wiring
of the extension unit side by this point.
Start
Yes
No
To the next page
Change the network information for the
target control unit.
Refer to
7.5 Setting of Terminals .
Connect the parent terminal of control unit
and the computer with a LAN cable.
Change the control operation state of the control unit to STOP.
It can be changed both from the unit and from the software.
Execute it from either of them.
Control unit operation Software operation
Set the STOP/RUN switch of the unit to STOP.
Change the control operation state of the unit.
Refer to
7.13 Change of RUN/STOP .
Turn off the auxiliary power for every
control unit in the system. The output state of every control unit in the
system is switched to OFF.
Disconnect every control unit in the
system and the control target equipment.
Yes
Have you set up the network
information for every target control unit?
No
Is the network information change
required?
Operation of Control unit
Connect the parent terminal and the
computer with a LAN cable.
When the control operation state is changed
to STOP, the output state is as follows.
Control method Output state
Interlocking control Retention
Compressor control All OFF
Schedule control Retention
<Example that network information must be changed>
Increase/decrease of the terminals, change of
installation place, etc.
Make a one-to-one connection between
the control unit and the computer with a
LAN cable.