Mitsubishi Electric EMU4-CNT-MB, Руководство пользователя

Страница: 38 / 136

37
6.2 Basic Operation
The following table describes the procedure of each operation.
Reference Item Details
6.2.1 Checking the control status How to check the present control status of each control unit.
6.2.2 Manually operating the
contact output/analog
output How to manually control the contact output/analog output of the control
unit.
6.2.3 Changing the control
setting How to change the control setting. (but not the control type)
6.2.4 Changing the control type How to change the control type.
6.2.5 Changing the IP address How to change the IP address of the parent terminal.
6.2.6 Setting the clock How to set the control unit clock to the present time.
*The clock accuracy is five minute per month difference. Check the clock
time regularly, and if there is a difference, adjust the time.
*When the clock is reset due to battery exhaustion or its replacement, this
item should be referred.
6.2.7 Acquiring the event log
(The latest 10 logs) How to output the event logs from the control unit without stopping control.
*The latest 10 event logs are output.
6.2.8 Acquiring the event log
(All logs) How to output the event logs from the control unit with control stopped.
*All the event logs are output that the control unit stores.
6.2.9 Updating the firmware How to update the firmware of the control unit.
6.2.10 Changing the control
setting with updating the
firmware How to change the control setting but not the control type at the same time
when the firmware of the control unit is updated.
Checking the Control Status
Operation of Control unit Operation of Control Unit Engineering Tool
Check the control status of the control unit
on the control monitor window.
Refer to
9 Control Monitoring .
Connect the parent terminal of control unit
and the computer with a LAN cable.
End
Start