Mitsubishi Electric EMU4-CNT-MB, Руководство пользователя

Страница: 39 / 136

38
Manually Operating the Contact Output/Analog Output
Operation of Control unit Operation of Control Unit Engineering Tool
Change the output state of contact/analog
output.
Refer to
9.2 Manual Control of
output .
End
Start
Connect the parent terminal of control unit
and the computer with a LAN cable.
Change the control operation state of the control unit to RUN.
It can be changed both from the unit and from the software.
Execute it from either of them.
Control unit operation Software operation
Set the STOP/RUN switch of the unit to RUN.
Change the control operation state of the unit.
Refer to
7.13 Change of RUN/STOP .
Setting the control operation state to RUN starts the
control. Execute it in good condition to operate.
When the output state of contact/analog
output is changed, the control operation
state of the unit will automatically change to
STOP. At this time, any output states other
than the changed output are as follows.
Control method Output state
Interlocking control Retention
Compressor control All OFF
Schedule control Retention