Mitsubishi Electric CR750-D Series, Инструкция по эксплуатации

Страница: 105 / 126

4Basic operations
Programming 4-93
■ Input the described program into the controller.
The T/B is used for this operation.
1) Set the controller mode to "MANUAL".
2) Set the T/B [ENABLE] switch to "ENABLE".
3) In the <MENU> screen, press the arrow keys
(" ↑ ", " ↓ ", " ← ", " → ") and move the
cursor to "1. Management and edit", and
then press the [EXE] key. The <Management
and edit> screen will appear.
4) Press the [F3](New) key, and display the new
program screen.
5) Press [1], [EXE] key, and display the edit
screen of program No1.
Down： ENABLE
*Lighting
Up ： DISABLE
Rear of T/B
<MENU>
1.FILE/EDIT 2.RUN
3.PARAM. 4.ORIGIN/BRK
5.SET/INIT. 6.ENHANCED
CLOSE
123
Preparing the T/B
MODE
MANUAL AUTOMATIC
～
<FILE/EDIT> 1/20 Rem 136320
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08 694
A1 08-04-24 13:05:54 2208
B1 08-04-24 13:05:54 1851
COPY 123 POSI.
EDIT
NEW ⇒
<NEW PROGRAM>
PROGRAM NAME
(
1 _ )
CLOSE
ABC
<PROGRAM> 1 100%
TEACH 123
DELETE
EDIT INSERT
⇒
◇◆◇ Using the T/B ◇◆◇
Set the controller mode to "MANUAL" and the T/B [ENABLE] switch to "ENABLE". Operations from the T/B
are not possible unless the controller mode is set to "MANUAL".
◇◆◇ Inputting numbers ◇◆◇
Each time the [CHARACTER] key is pressed, the number input mode and the character input mode change.
The current input mode is displayed in the center under the screen, and the display of "123" shows that the
number input mode. The number currently written to the lower left of each key in this state can be inputted.
◇◆◇ Correcting incorrect numbers ◇◆◇
Press the [CLREAR] key to delete the character, and then input it again. And, if the long pushing [CLEAR] key,
all the data in the parenthesis can be deleted.
If the cursor is returned by pressing the [ ← ] key, and a character is input, it will be inserted.