Mitsubishi Electric AnyWire ASLINK, Руководство пользователя

Страница: 164 / 200

162
APPX
Appendix 3 Remote Buffer Memory
Parameter area initialization command
■
Address
■ Description
This area is used for clearing the parameter information stored in the non-volatile memory, such as when Non-volatile memory
data error (parameter) (error code: 2010H) occurs.
Setting a fixed bit other than 0 does not cause an error.
(1) 0: No command, 1: With command
If 1: With command is selected for b0, the parameter information of the non-volatile memory is initialized and the initial value
is stored in the non-volatile memory. (The initial value is set to 0: No command.)
The initial values are stored in the monitor area and parameter area after the module is powered on and off.
Name Address
Parameter area initialization command 0402H
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
0 (1)
ON
ON
ON
OFF
ON
OFF
OFF
ON
Module power supply remote reset
Address: 0402H bit 0
Parameter area initialization command
Monitor area
Parameter area
Non-volatile memory
Error status flag (RX5)
Initial value
Address: 0403H bit 0
Parameter area initialization completion
SLMPSND instruction
Executed by the NZ2AW1GNAL
Executed by the program
Periodically read and check with the SLMPSD instruction. Periodically read and check with the SLMPSD instruction.
Setting value A
Initial value Initial value
During parameter error
Initial value
Setting
value A
Setting
value A