Kaleido-X (7RU)
Quick Start Guide
11
Powering Up The Kaleido-X (7RU)
To power up the Kaleido-X:
•
Plug both power cords from the Kaleido-X into a grounded power outlet.
The startup sequence takes approximately four minutes, during which time some video may appear on the
displays. The startup is completed when the CPU LEDs of the output cards (second LED from the top) are
solid green.
Verifying that the Cards are Ready
To verify that the cards (modules) are ready:
•
Check the status LEDs on each card installed in the Kaleido-X frame. Make sure that none are indicating
an error condition (see table below).
IMPORTANT:
At initial startup, after your system has auto-detected the resolution of the display, it is
strongly recommended that you manually set the output resolution and clear the
Use
detected monitor resolution
check box.
IMPORTANT:
If you have a KXA-FR7-B frame, make sure a ground cable (not included) is connected
between the frame and the rack before plugging any of the power cords into a power
outlet (see page 8).
Note:
The Kaleido-X (7RU) does not have power switches, and will start up as soon as it is plugged in.