GUIDE TO INSTALLATION AND OPERATION
XVP-3901 |
23
5.2.1 Input/Output Config Tab
Input Config:
use the pulldowns to select the rear panel
input that will be used when the inputs are selected:
•
BNC IN – use one of the electrical inputs
•
Fiber IN – use one of the fiber optic inputs (1, 2 or
both will be listed)
•
The pulldowns are greyed and non-functional if the
installed rear panel does not incorporate a fiber SFP
socket
•
If the Fiber Input name is red in the pulldown, it
indicates that an appropriate fiber module has not
been detected in the SFP socket
BNC Output Config:
Use the pulldowns to select whether
the named output will be HD or SD.
Fiber Output Config:
Use the pulldowns to turn the fiber transmitters for each output ON (either HD OUT or SD OUT)
or OFF
•
This section of the panel only appears when a rear module with a fiber SFP socket is installed
•
If the selection is invalid (e.g. no appropriate transmitter installed in the SFP socket) then the selection will be
red in the pulldown and a warning message will appear if it is selected
•
Information about the installed SFP module can be found in the SFP Info tab, which only appears when a rear
module with a fiber SFP socket is installed
5.2.2 Input 2 tab
Input 2 Mode:
Specify the operation mode for the second
input using the pulldown. Available choices are:
2x1 Switch:
when this mode is selected, the card can be
manually switched between the 2 inputs, using the radio
buttons in the
Input Select
area. Keep in mind that all
current settings (ARC, audio, etc.) will remain and be
applied to input 2.
Fail Over:
when this mode is selected, the card will
automatically switch from input 1 to input 2 when input 1
is lost for a delay longer than the
Auto Switch Delay
set
below.
•
All current settings (ARC, audio, etc.) will remain and
be applied to input 2.
•
The card will remain on input 2, even if input 1 returns to normal, until it is manually reset to input 1
Auto Switch Delay (sec):
using the slider, set the
Auto Switch Delay
, from 0 to 15 seconds in steps of 1 second.
Some points to note for the Failover mode:
•
The Failover mode only switches from input 1 to input 2, not from 2 to 1.
Figure 5.3 Video Input/Output – I/O Config tab
Figure 5.4 Video Input/Output – Input 2 tab