MIOX RIO-S Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 77

MIOX RIO-S Series Operators Manual
102-00130-D Page 23
 Data Translator
o
Allows data mapping between the PLC, and the various sensors connected to
the RIO-S as well as between these sensors and any SCADA system that the
unit is connected to.
 LED indicator
o
Located on the external door to the cabinet, displays different colors and light
patterns to indicate the status of the OSG. Refer to the Interface Elements
section of this manual for more information.
 Cellular Modem (if equipped)
o
If your RIO-S came equipped with remote monitoring, this Modem is the
hardware that supports that functionality. Refer to the Communications
section of this manual for more information.
 Safety Controller
o
Control System that monitors the various input devices (E-STOP, Leak Detect,
Door Interlocks, etc.) that correspond with the safe operation of the unit.
 Uninterruptible Power System (UPS)
o
In the event where power to the OSG is lost, the UPS provides ample power
to allow the electronically controlled valves to turn off to prevent overflow.
Additionally, the UPS allows the system to send communications data to a
SCADA system or other monitoring system in the event of a power loss.
Switchgear Cabinet
The RIO-S switchgear cabinet comes completely wired from the factory. If needed, refer to
Figure 9 for the locations of all major electrical components, and below for a summary of
the more operator-relevant components. If there is an event where additional clarification is
needed, please contact your MIOX Customer Support provider.