Minuteman SCV 28/32, Операционное обслуживание комплектующих и уход, Страница: 23 / 84

23
d. Align the notches on the brush with the drive pins on the hub.
e. Push the brush all the way in until it bottoms out.
f. Insert the access door hub into the other end of the brush.
g. Reinstall the wing nuts and yellow 3 sided knobs and tighten.
IMPORTANT NOTE WHEN INTERCHANGING SCRUB DECKS
As previously mentioned, the scrub deck brush pressure is computer controlled.
However, when interchanging the two types of decks, an additional step must be taken
to ensure that the controller correctly compensates the pressure for the type of deck
that is currently installed.
Inside the main electrical box, beneath the seat there is an Orange/Violet jumper wire
(shown disconnected in Figure 1) that may or may not be connected to the terminal
block, depending on the type of scrub deck that was originally ordered with the
machine. When using the
Disk Scrub Deck , the wire is disconnected . When using the
Cylindrical Scrub Deck , the wire is connected to the terminal block located in the
electrical box, beneath the TRIO Controller. This terminal block is divided into five
sections, each separated by a divider. The four leftmost sections contain one column
each of spade terminals. The section on the right contains two columns of spade
terminals (
this section also contains four Red/Black wires, not shown in Figure 2
for clarity ). The Orange/Violet wire must be connected to a spade terminal in the
section with two columns when using the Cylindrical Scrub Deck ONLY!
When switching from the Cylindrical Scrub Deck to the Disk Scrub Deck,
be sure to
disconnect the Orange/Violet wire. When switching from the Disk Scrub Deck to the
Cylindrical Scrub Deck, connect the Orange/Violet wire to any available spade terminal
in the section that contains two columns (shown in Figure 2) and the Red/Black wires.
Figure 1 Figure 2
Jumper wire disconnected Jumper wire connected to
terminal block