Minuteman SCV 28/32, Операционное обслуживание комплектующих и уход, Страница: 12 / 84

12
CONTROL CONSOLE
For operator ergonomics, the control console houses all the primary function controls in a
central area. The key switch and optional headlight and off-aisle wand switches are clustered in
the back portion of the console. The directional switch (forward/reverse) is located at the front of
the console for easy fingertip operation. The horn button, function selectors, and battery gauge
are located in the central part of the console.
KEY SWITCH (A) –
Controls the machine’s power (ON/OFF) with a key for safety. All
operational settings are retained even when the power is turned off and on. This also serves as
a reset switch when errors or faults occur.
OFF AISLE WAND SWITCH (OPTIONAL) (B) –
ON/OFF control for the water supply to the
wand and vacuum motor for the optional Off-Aisle Wand.
HEADLIGHT SWITCH (OPTIONAL) (C) –
ON/OFF control for the optional headlights.
BATTERY GAUGE (D) - Displays the level of charge remaining in the machine’s batteries. The
gauge consists of 10 LEDs. (3 Green, 4 Amber, 3 Red) If the battery life is low, the battery
gauge bar icon will be flashing to inform the operator that the machine is almost out of power.
Once this signal is displayed, all functions will shut off, including transport mode. The operator
must then
turn the key switch OFF and then ON to reset the machine. The machine will then
have only a few minutes left of reserve power to briefly use Vacuum Only mode to pick up any
remaining solution on the floor and Transport mode to return to the charging station. This gauge
will also display a fault code if the system has an error. This code is represented by a specific
number of flashing LEDs.
See Fault/Diagnostic Codes for specific code information.
SOLUTION CONTROL KNOB (E) –
Adjusts the amount of solution being dispensed to the
floor while in one of the scrub modes. Turn the knob clockwise to increase the amount of
solution being dispensed. The amount of solution applied is variable to a maximum of 1 GPM.
MODE SELECTOR KNOB (F) –
This knob is used to select the desired operation mode of
the machine. See Operation Modes for information about each mode.
HORN BUTTON (G) – Depressing
this button will activate the machine’s horn.
DIRECTIONAL SWITCH (H) –
Flipping this switch to the down position will set the machine
to move forward. Flipping it to the up position sets the machine to move in reverse.