minrray UV401, Руководство пользователя

Страница: 19 / 37

- 18 -
3
、
Use of remote control
Operating instructions for remote control: Remote control is classified into IR remote control and
wireless remote control; please read the following based on the type of remote control.
3.1 Pairing for Wireless Remote Control
Wireless remote control: The procedures for operation, pairing and clearing
pairing data are as follows.
One-to-one pairing
Press and hold "Set" and "*" keys for 3 seconds, and the LED will begin to
flash; release the keys, and the LED will keep flashing; start the pairing, and
power on the receiving device; the LED will go off if the pairing is successfully
finished; after one-to-one pairing, this product is controllable only by this
remote control; to use another remote control, it's necessary to clear the pairing
data of the original remote control or to pair the new one. If the pairing fails,
the red LED will go off after flashing for 20 seconds, then the device will stop
pairing and get into Sleep; at this point, you can press any key to wake up the
device for pairing.
Note: To enable the control after successful pairing, the camera
address must be selected.
Clearing Pairing Data
Press "Set" + "#" keys, and the LED will start to flash continuously, and then power off and on
the receiving device; when the LED goes off, it means the pairing data has been successfully cleared.
Sleep and Wake-up
The Sleep mode is activated immediately after no operation is performed in working state; you
can press any key to wake the device up.
The keys and operating method of IR remote control are the same as wireless remote control.