Minolta CA-100PLUS -, Инструкция по эксплуатации

Страница: 72 / 126

69
Settings Section
2. Setting the Analog Display Range
The analog display section displays the difference (%) between the measured value and the target color as well as
the difference (%) between measured values in the case of a measurement mode.
The range for each dot can be set as follows.
1
xyLv, T
∆
uvLv, u'v'Lv or XYZ measurement mode .....
∆
x,
∆
y and
∆
Lv
2
Analyzer Mode
For G-reference .............. R/G, B/G and
∆
G
For R-reference ...............
∆
R, B/R and G/R
The range must be set independently of
1
and
2
.
In the case of
1
, the range set here will be used commonly by all the modes. Thus, for instance, if
∆
x and
∆
y
are set to 2% and
∆
Lv is set to 10% for xyLv mode,
∆
x and
∆
y will be displayed in 2% and
∆
Lv in 10%
irrespective of the measurement mode (xyLv, T
∆
uvLv, u'v'Lv or XYZ).
In the case of
2
, the value set for G (G-reference), the value set for R (R-reference), the values set for R/G
and B/G (G-reference) and those set for B/R and G/R (R-reference) will be common. Thus, for instance, if
∆
G is set to 5% and both R/G and B/G are set to 3% in the case of G-reference,
∆
R will be displayed in 5%
and both B/R and G/R in 3% in the case of R-reference.
●
Settable range ........... 0.1 to 99%
–In 0.1% step for the range from 0.1 to 9.9%
–In 1% step for the range from 10 to 99%
●
How to Read Analog Display
When n% range is set
Below
±
n%
Below
±
n
×
2%
Below
±
n
×
4%
Below
±
n
×
8%
– +
For xyLv, T
∆
uvLv, analyzer, u'v'Lv or XYZ mode
Red Green Red
–n
×
8%
or lower
+n
×
8%
or higher
•
Values displayed in the analog display section
For xyLv, T
∆
uvLv, u'v'Lv or XYZ mode
∆
x =
x
t
x
−
x
t
×
100 (%)
∆
y =
y
t
y
−
y
t
×
100 (%)
∆
Lv =
Lv
t
Lv
−
Lv
t
×
100 (%)
where, xt, yt, Lvt : Target color values
x, y, Lv : Measured values
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com