MINOLTA-QMS magicolor 2350, Руководство пользователя

Страница: 163 / 208

Installing an Internal Hard Disk
161
En
g
lis
h
2
Remove the rear panel from the
printer to access the controller board.
Using a screwdriver, loosen nine
screws on the top, left and bottom of
the panel, but do not remove them
from the printer.
3
Remove the two screws shown in the
illustration. Slide the panel slightly to
the right and lift it off the printer.
4
Next prepare the daughterboard for
installation. If you purchased an inter
-
nal hard disk kit, skip to Step 6. If you
purchased a hard disk from another
vendor and purchased only the
daughterboard kit, you must now
attach the hard disk to the daughter-
board.
5
Attach the ribbon cable to the hard
disk, aligning Pin 1 on the cable to pin
1 on the hard disk.
6
With the cable connected, set the
hard disk flat on the daughterboard.
Then, using a screwdriver, insert the
four screws that came with the kit. Be
careful not to overtighten the screws.
7
Align the daughterboard over its con-
nector, matching Pin 1 on the daugh
-
terboard to Pin 1 on the controller
board and matching the two white
nylon standoffs to the holes in the
controller board. Ease the pinned
connectors together and snap the
standoffs into place.
8
Slip the rear panel over the screws,
then slide it slightly left and tighten
the screws to secure the panel. Also
replace the two screws removed in
Step 3.