Minebea Intec PR 5211 Series, Инструкция по эксплуатации инструмента, Страница: 85 / 96

If the standstill timeout is exceeded in a function which needs the standstill condition, the
function will be aborted (taring parameters, set zero, calibration, 'P'-command of the
SMA-protocol). In addition, the error code 31 and the 'CmdError' bit will be set.
7.5.15 Parameter P47: Zero range
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0
Byte 1
Byte 2 RANGE MSB
Byte 3 RANGE LSB
RANGE: 0 … 500.00 d, default = 50 d
Value = d x 100
7.5.16 Parameter P48: Zerotrack range
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0
Byte 1
Byte 2 RANGE MSB
Byte 3 RANGE LSB
RANGE: 0 … 500.00 d, default = 0.25 d
Value = d x 100
7.5.17 Parameter P49: Zerotrack step
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0
Byte 1
Byte 2 STEP MSB
Byte 3 STEP LSB
STEP: 0 … 10.00 d, default = 0.25 d
Value = d x 100
7.5.18 Parameter P50: Zerotrack repeat
Repeat interval of Zerotrack
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0
Byte 1
Byte 2
Byte 3 REPEAT
REPEAT: 0 … 100 measurement times, default = 0 (Zerotrack is off)
7 ProfiBus interface Transmitter Series PR 5211
EN-83 Minebea Intec