MIMAKI TS3-1600, Руководство по эксплуатации

Страница: 123 / 206

4-5
4
Routi
n
e Ma
int
ena
nc
e
Maintaining Capping station
Maintain Ink cap, Wiper or the like, which are located in the capping station. [ST.MAINTENANCE]
The ink cap and wiper function respectively as follows.
• Wiper : Wiping ink sticking to the head nozzle off.
• Ink cap : Preventing the head nozzle from clogging due to drying.
As the machine is used, the wiper and ink caps gradually become stained with ink and dust.
If nozzle missing cannot be corrected even after executing the Head Cleaning (
P.2-24) , use Cleaning kit
and clean stick.
Cleaning the wiper and ink caps
It is recommended to perform cleaning frequently in order to maintain the high image quality and keep the
machine in good condition.
1
Press the key in the local mode.
2
Press the key.
• The carriage moves onto the platen.
3
Open the front cover then remove the
wiper.
• Pull out the wiper by holding the projections at
both ends.
Tools required for
Maintenance
• Cleaning solution
When solvent ink is used:
Cleaning solution MS2/ES3/HS kit (SPC-0369)
When sublimation dye ink is used :
Cleaning Liquid Bottle Kit A29 (SPC-0137)
• Clean stick (SPC-0527) • Gloves • Goggles
• Be sure to wear the attached goggles and gloves for works when the maintenance of the
capping station is performed. If not, ink may be caught in your eyes during the works.
• Do not move the carriage out of the capping station by hand.
• When it is desirable to move the carriage, press the
key to execute the carriage-
out. ( P.4-5 the step 1 - 2)
• When SS21 ink is used, the ink sticks around the wiper easily. Clean the wiper and
surroundings about twice in a week (it varies, depending on frequency of use of the machine.)
• Replace the wiper with a new one if it is badly soiled or curled. ( P.4-7)
• Be careful not to leave lint of the cotton swab. Lint may cause printing failure.
S T . MA I NT ENANCE
CARR I AGE OUT
< e n t >
Projection