MIMAKI ME-300STII, Руководство по эксплуатации

Страница: 53 / 90

How to Send Data from the Host
3-17
How to Send Data from the Host
Before sending data from the host, check the setting is correct and the work is firmly set, and then go
to the operations below.
1
Adjust rotation speed of the spindle as
needed.
2
Press to change to the remote
mode.
3
Send data referring to the operation manual
of the host.
4
When engraving is finished, remove the
work.
Press to change to the local mode.
Move the head to its waiting position ( P.4-5), and
remove the work.
Check around this machine before sending data.
Before sending data, check there is no people around this machine (within one meter or less).
This machine starts to work immediately after receiving data. The head or the table moved sud-
denly could contact and injure human body around this machine.
To stop operation during engraving, select from two ways as follows.
Emergency stop (
P.2-5)
If abnormal action of this machine could break this machine or injure the worker, press the emer-
gency switch. If pressed, the power is turned off and all the transmitted data is erased.
Change to the pause mode. (
P.2-12)
If there are obstacles on the work or the table, change the mode to PAUSE.
After removing the obstacles in the pause mode, you can continue engraving.
[ R e m o t e ] 0 K B
S p i n . O n F C o m . II C
Z D : 1 . 0 0 Z - E S : 1 0
Z C : 2 . 0 0 X Y E S : 4 0
[ L C L ] S p i n - O F F 1 / 4
C o n d i t i o n - - >
T e s t C u t - - >
D a t a C l e a r - - >