MIMAKI JFX-1631/1615 Plus, Руководство по эксплуатации

Страница: 29 / 154

1-11
1
Before U
se
About Media
The sizes of media that can be used and the method of handling are described here.
The sizes of media that can be used
Precautions in handling the media
Carefully observe the following when handling the media.
JFX-1631/JFX-1631plus JFX-1615/JFX-1615plus
Maximum width
1644 mm
Maximum length 3194 mm 1592 mm
Max. drawing width 1602 mm
Max. drawing length
3100 mm 1500 mm
Thickness Less than 50mm
Weight
*1
*1. A rough guide is 50 kg per 1 m
2
.
Less than 200 kg Less than 100 kg
• Extension and shrinkage of the media
Do not use the media in the sheet form shortly after the package was opened. The media could extend
or shrink depending on the temperature and humidity inside the room. For more than 30 minutes after
opening of the package, the media has to be exposed to the ambient air of the location it is to be used.
• Warping of the media
As for the media of the sheet form, use the flat one, or the one warping downward (the one with floating
central part when placed the drawing surface facing upward.) The media warping upward could not be
absorbed in some cases onto the table. Store the media liable to be warped on the slightly smaller
platform or palette so that it may warp downward.
Be careful not to warp the media out of the absorption area.
• Absorption of the media
To maintain the absorption effect, cover the suction holes not covered by the media with other media
which is thinner than the media.
• Other precautions
a Do not place any article on the surface of the coated paper. Some coated paper could change its
color.
b Curled media that cannot be absorbed or the media that misaligns when the Y-bar is moved may not
be used. Before using, fix the media with adhesive tape, etc.
c Do not use the media that will generate warping or deformation even if the logical seek is set “OFF”.
d As the bed surface is constructed of multiple boards, their joint lines could be reflected on the printed
images depending on the thickness and elasticity of the media. Similarly, the suction holes could
affect the printed images. Perform the printing after confirming that there is no problem by making the
test printing in advance.