MIMAKI 3042 MkII EX, Руководство по эксплуатации

Страница: 28 / 126

Chapter 1 Before Use
1-12

Removing USB memory
If a USB memory module is inserted in the personal
computer to which a this machine machine is
connected, click "Stop" in the "Safely Remove
Hardware" window by following the instructions given
there first and then remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.
Connecting the LAN cable
When connecting LAN cable, be sure to follow the note
below:
Printing Via a Network
If printing via a network, you need to configure your
network with the following environment.
If you configure it with an inappropriate environment, it
could cause printing to stop.
• Use LAN cables that are category 6 or higher.
• Use a switching hub and PC that support 1000BASE-T.
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1)
Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
(2)
Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Connecting the power cable
About ink bottle
There are 8 ink bottles (6 bottles for 3042 MkII/3042 MkII
e) on the left side of the machine.
Kinds of ink that can be used
• Surely insert LAN cable until clicking noise
sounds.
• Do not plug in or unplug any cable during data
transferring.
• Set the PC sending the print data and the printer
to the same network.
• You cannot connect via a router.

If connecting directly to the printer
Color Lit? Condition
Green
ON Connected with 1000BASE-T
OFF Connected without 1000BASE-T
Yellow
ON Link-up
Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
• Use only the supplied power cable.
• Be sure to connect the power cable plug to the
grounded outlet, or it may cause fire or electric
shock.
• Take care not to damage, break or work upon the
power cable. Or if putting a heavy thing on,
heating, or pulling the power cable, the power
cable can break to cause fire or electric shocks.
Switching hub

If connecting via a switching hub