Milwaukee 202B Series, Руководство оператора

Страница: 4 / 12

4
FUNCTIONAL DESCRIPTION
1. Jacket and Pocket Power Buttons
High: Red LED
Medium: White LED
Low: Blue LED
2. Power Cable
3. Battery Controller Pocket
1
2
3
BACK
SPECIFICATIONS
Cat. No. ........................202B Series, 202G Series
202R Series, 222C Series, 232B Series
Volts .............................................................. 12 DC
Battery Type ................................................. M12™
Charger Type................................................ M12™
SYMBOLOGY
Volts
Direct Current
Machine wash, gentle cycle in warm water
Do not bleach
Do not wring or twist
Tumble dry, low heat
Do not iron
Do not dry-clean
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe -
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body of
the battery controller. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
controller pocket) into the power cable port on the
battery controller.
Place the battery controller into the pocket and zip
closed. If necessary, unzip the expansion zipper to
accommodate larger battery packs.
To
remove
the battery, push in the release buttons
and pull the battery pack away from the controller.
OPERATION
The zone power buttons are located on the upper left
side of the jacket. Use the jacket and pocket
power buttons to control the two zones.
To turn on , press and hold (1 to 2 seconds) the
zone’s power button. The zone will be turned to High
and the red LED will light.
Temperature setting can be adjusted at any time
by pressing the zone’s power button. Each press
will cycle through the zone’s temperature settings.
To turn off the heated jacket, press and hold (1 to 2 sec -
onds) the zone’s power button. The LED will turn off.
If the heated jacket turns off unexpectedly, check
connections and charge the battery pack.
JACKET CARE
WARNING
To reduce the risk of injury, always
unplug the charger and remove the
battery pack and battery controller from the
heated jacket before performing any mainte -
nance. Never disassemble the heated jacket,
battery pack or charger. Contact a MILWAUKEE
service facility for ALL repairs.
If the heated jacket does not start or operate properly
with a fully charged battery pack, clean the contacts
on the battery pack. If the heated jacket still does
not work properly, return the heated jacket, charger
and battery pack, to a MILWAUKEE service facility
for repairs.
WARNING
To reduce the risk of personal in-
jury and damage, disconnect and
remove battery pack and battery controller from
battery controller pocket before washing. Never
immerse your battery controller, battery pack, or
charger in liquid or allow a liquid to flow inside
them.
To clean the heated jacket:
1. Remove battery pack and battery holder.
2. Push the power cord completely into the battery
holder pocket and fasten closed.
3. Machine wash, Gentle Cycle in warm water. Do not
use bleach. Do not dry clean. Do not wring or twist.
4. Tumble Dry on Low Heat. Do not iron.