Milltronics OCM II PL-269, Инструкция по эксплуатации

Страница: 90 / 107

APPENDIX D
AUXILIARY PRINTER
The OCM II can be connected to a serial printer via the RS232 terminals and programmed to print at regular
intervals. The choices are every minute or whole minute that will divide into 60 evenly, or every hour or whole
hour that will divide into 24 evenly, or once a day (P17 & 18). Thus for interval of 15 minutes (P17 = 0; P18 = 15)
the printout will be on the hour, 15 after, 30 after, and 45 after the hour. For an interval of 8 hours (P17 = 1; P18
= 8) the print out will be at 00:00, 08:00 and 16:00 hours. When set for once per day the hour of the day can be
set when to print. To print at 08:00 hours every day (P17 = 2; P18 = 8)
The output format is as follows:
Date 18/05/89
Time 09:12:00
Site Number 1.000000
Head 24.86000
Velocity 12.26000
Temperature 17.10000
Flow Rate 2249.248
Flow Total 325468.9
Should there have been a power failure then the OCM II will output:
PRINTER READY
18/05/89 09:15:00 (date and time power resumed)
Four seconds after power has returned.
The print output can be in English, French, German, or Italian. (P16 = 1, 2, 3, or 4 respectively, 0 = no print)
The output format is a string of ASCII characters terminated by a carriage return. A line feed is not sent. The
printer must perform an automatic line feed upon receipt of the carriage return message. Lines are less than 40
characters sent once every 2 seconds. Only upper case, lower case, numbers, and punctuation marks are used.
In the Run Mode ( F 2 ), an immediate printout may be obtained by pressing the "A" key on the OCM II keypad.
PL-269 9 – 12