Miller OM-246 022B, Руководство пользователя

Страница: 16 / 26

OM-246 022 Page 14
3-11.
Remote Control For Welding Power Source With Output Contactor And Amperage Or
Voltage Control
Hand control operation for welding power
sources with remote output contactor con-
trol (Stick and TIG welding).
! Unexpected weld output can cause
electrical shock. Wireless remote con-
trol can turn weld output on from dis-
tant locations. Disconnect receiver
from remote 14 receptacle and remove
battery from remote control before ser-
vicing equipment.
1 Welding Power Source Output Control
Switch
This setting allows welding power source out-
put contactor to be remotely activated or deac-
tivated, and output can be remotely increased
or decreased.
2
Output Contactor Control Button (Green)
3 Decrease Button
4 Increase Button
5 Remote Output On Indicator (Blue LED)
6 Display Screen
7 Display Screen Button
Press and hold output contactor control button
(1 second) to turn on welding power source
output contactor. Display screen and remote
output on indicator (blue LED) stay on while
output contactor is on.
To turn off weld output contactor, press output
contactor control button. Display screen stays
illuminated for 10 seconds, and then defaults to
the percentage mode.
Press increase/decrease buttons to illuminate
display and change weld output in 1 percent in-
crements of welding power source panel set-
tings. Hold buttons to adjust weld output in 5
percent increments. Display turns off after 10
seconds of non use to conserve battery.
.
Some welding power sources are not
equipped with voltage and amperage feed-
back, and cannot display voltage and am-
perage.
Press display button to display actual amps,
volts, or the percentage of weld output. Amper-
age or voltage can only be displayed while
welding, or while weld output is on.
1
2
3
4
5
6
7
805 482-A