Miller OM-246 022B, Руководство пользователя

Страница: 18 / 26

OM-246 022 Page 16
3-13.Programming A Hand Control
Ref. 803 900 / 805 486
! Unexpected weld output can
cause electrical shock. Wire-
less remote control can turn
weld output on from distant
locations. Disconnect re-
ceiver from remote 14 recept-
acle and remove battery from
remote control before servi-
cing equipment.
! Turn off welding power
source where wireless re-
mote control was installed
before linking wireless re-
mote control to another unit.
During the programming
process, weld output may be
present on machine previ-
ously linked to wireless re-
mote control.
.
Hand control and receiver are
programmed when purchased
as a pair. Programming is only
required for devices that have
not been programmed (paired).
Once the devices have been
paired, the address is saved
and can only be changed if the
programming procedure is con-
ducted with a new device. Only
one control can operate a re-
ceiver
1 Receiver
2 LED
3 Learn Button (Miller Logo)
.
Be sure receiver has been cor-
rectly connected to the power
source Remote 14 receptacle
(see Section 3-7), before pro-
ceeding with programming pro-
cedure.
.
Hand control must be within
one foot of receiver for suc-
cessful programming to occur.
Verify LED is lit.
4
Hand Control
5 Display Screen
6 Decrease Button
Press and hold Learn button and
LED will begin to blink slowly.
While continuing to hold Learn but-
ton, press and hold Decrease but-
ton until [Lrn] is shown on display.
The LED will blink rapidly when suc-
cessful programming has occurred.
1
2
3
4
5
6
Lrn