Miller OM-246 022B, Руководство пользователя

Страница: 15 / 26

OM-246 022 Page 13
3-10.
Remote Amperage Or Voltage Control For Welding Power Source With Output Always On
Hand control operation for welding power
sources with output contactor always on
(Stick, TIG, and voltage sensing wire feed
welding).
! Unexpected weld output can cause
electrical shock. Wireless remote con-
trol can turn weld output on from dis-
tant locations. Disconnect receiver
from remote 14 receptacle and remove
battery from remote control before ser-
vicing equipment.
! Weld output is always on.
1 Welding Power Source Output Control
Switch
This setting only allows weld output to be re-
motely increased or decreased.
2
Output Contactor Control Button (Green)
3 Decrease Button
4 Increase Button
5 Remote Output On Indicator (Blue LED)
6 Display Screen
7 Display Screen Button
Output contactor control button does not turn
on/off welding power source output contactor.
The output contactor control button is used to
activate the display for viewing actual amper-
age and voltage if the machine has these cap-
abilities. To activate, press and hold for 1
second. To deactivate, press and release.
Press increase/decrease button to illuminate
display and change weld output in 1 percent in-
crements of welding power source panel set-
tings. Hold buttons to adjust weld output in 5
percent increments. Display turns off after 10
seconds of non use to conserve battery.
.
Some welding power sources are not
equipped with voltage and amperage
feedback, and cannot display voltage and
amperage.
Press display button to display actual amps,
volts, or the percentage of weld output. Amper-
age or voltage can only be displayed while
welding or while weld output is on.
1
2
3
4
5
6
7
805 482-A