Miller Auto-Axcess E Digital, Руководство пользователя

Страница: 76 / 164

OM-257 675 Page 70
A. System Reset Mode
.
System Reset is not active when
Program Lock is enabled.
System Reset allows the operator to
reload factory program settings for all
eight active programs in the unit.
.
System configuration data will be
lost during the Reset operation.
Press the Setup push button to
select the reset mode.
Rotate Adjust knob until System Reset
(SYS RST) appears on the display.
Rotate Adjust knob to select NO or YES.
Program 1 Pulse
.035 Mild Steel
90% Argon, 10% CO
2
Program 2 MIG
.035 Mild Steel
75% Argon, 25% CO
2
Program 3 Accu-pulse
.035 Mild Steel
90% Argon, 10% O2
Program 4 Pulse
.045 Mild Steel
90% Argon, 10% CO
2
Program 5 MIG
.045 Mild Steel
75% Argon, 25% CO
2
Program 6 Accu-pulse
.045 Mild Steel
90% Argon, 10% O2
Program 7 Pulse
.052 Mild Steel
90% Argon, 10% CO
2
Program 8 MIG
.052 Mild Steel
75% Argon, 25% CO
2
Unit will go through a soft boot and then
begins initialization (see Section 10-6).
During system reset the display flashes
please wait (PLS WAIT) and the
following factory default programs are
loaded into the unit:
The Arc Control push button LED
flashes indicating the unit is ready to
perform the system reset operation.
Press the Arc Control push button.
When System Reset is finished, the display
will show CYCL PWR for cycle power. Turn
the power source off and back on again.
SW
REV
SYS
RST
SYS
RST RST
NO
RST
YES
PLS
WAIT
CYCL
PWR
LED
Rotate Adjust knob to select NO or YES.
Program push button LED flashes,press
to enter reset selection. If NO is entered,
unit returns to standby mode.
RST
YES