MILLASUR Anova BIO150D, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 22

SECTION 5: SERVICE
Storage
EN
16
• Store the wood chipper in a well ventilated area. DO NOT store the machine in a
area that allows toxic gas emissions to reach areas inhabited by
the spark plug With the ignition off, gently pull the starter rope from
recoil. Replace the spark plug, continue to pull the recoil starter rope
Follow the guidelines below when storing your shredder:
people or animals.
until the piston is on the compression stroke (when resistance is felt). Then,
stop pulling.
• Remove the spark plug wire to prevent any accidental ignition.
• Close discharge chute baffle and place covers on hopper and funnel
to prevent any object or animal from accessing the machine.
Review the procedures and troubleshooting in this section to troubleshoot any problems your
machine may have.
• Empty the bag before storing to prevent plant material from rotting in the bag.
water-based degreaser that is respectful with the environment. Wait for it to dry completely
and then put the filter back. Caveat! Never run the engine without the filter installed.
• Store the shredder in a flat, dry place. If the shredder is not level,
• If you are not going to use the machine for more than a month, you should do the following
Figure 22
could leak fuel or oil.
Storage Procedure: Drain all fuel from the tank and carburetor. remove
fuel tank filter
Illustration 23
• Do not store the shredder near a source of ignition, such as a stove.
spark plug and pour about a tablespoon of clean engine oil into the spark plug hole.
Every 150 hours of operation or every three months, you should remove and the fuel tank filter
(Illustration 23) (23.1). Remove the fuel tank filter cap and filter, clean it well using an
environmentally friendly water-based degreasing agent, and install it again.
firewood, a gas or electric heater or any appliance with a pilot light.