MILLASUR Anova BIO150D, Инструкция по эксплуатации и техническому обслуживанию

Страница: 17 / 22

2. Spark plug wire not connected
or spark plug defective.
6. fuel line
1. Move the choke to the RUN position.
2. Blades or impeller have
woody residue or
4. Air filter is dirty.
2. The air filter is dirty.
1. Check that the ON/FF switch is in the
ON position, the fuel shutoff valve is open,
and the throttle and primer controls are in
the off position.
2. The air filter is dirty.
1. Blades are blunt or
2. V-belt is loose, worn, or
damaged.
6. Clean the duct
1. Clean the engine.
4. Clean the air filter.
irregular shape
overheats
1. Check blades, hammers, impeller and all
connections. Tighten, repair or replace all
damaged parts.
1. Sharpen or replace blades and make sure
hammers are undamaged.
1. Shut off the engine, disconnect the spark plug,
and then clean the machine.
2. The engine does not rev as
3. No fuel or fuel
is blocked
2. Clean the air filter.
The motor does not start
2. Connect spark plug wire or replace
spark plug.
3. Gasoline is stale, dirty, or has
water in it.
2. Clean the air filter.
to start.
5. Low engine oil level.
makes strange noises
damaged.
enough.
it's stale
1. Control levers are not in the
correct positions
1. Engine is warm and choke is
still in CHOKE position.
1. There are chips or sawdust around
the motor.
splinters stuck.
Chips do not come out 1. Discharge chute or hopper is
clogged. the download channel or
do it slowly
3. If empty, refuel. If you have fuel,
change it to fresh fuel.
The engine runs from
The engine is
2. Clean impeller or blades.
2. Put the throttle in the FAST position.
5. Add oil.
start.
3. Drain fuel tank, clean fuel line and
fill tank with fresh fuel.
1. Loose or damaged parts.
2. Replace or tighten V-belts.
The machine vibrates or
does not grind well
Shut off machine, wait for moving parts to come to a complete stop, and disconnect
spark plug wire before moving machine, emptying bag, unclogging intake and
discharge lines, refueling, or performing repairs or maintenance.
Problem Possible cause
Sharpen or replace blades as soon as performance suffers or you notice nicks, cracks, or dents.
Possible solution
EN
17
Problem resolution
Change of Blades
CAVEAT