Frequently Asked Questions
60
Message
Possible cause and solution
Clean the lint filter.
Check the airways.
continues to light
up after a
program has
been cancelled,
despite thorough
cleaning.
The plinth filter looks clean after thorough cleaning.
However, the program terminates and the fault
message appears again. It is likely that there is still
underlying residue that could not be removed.
To switch off the message: press
OK
.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
described in “Frequently Asked Questions –
Checking the heat exchanger”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions
described in “Frequently Asked Questions –
Replacing the plinth filter”.
If the plinth filter is not deformed or defective, you
can reactivate it in the washing machine. Follow
the instructions described in “Frequently Asked
Questions – Reactivating the plinth filter”.
Empty the container
or check the drain.
lights up after a
program has
been cancelled.
The condensed water container is full or there is a
kink in the drain hose.
Empty the condensed water container.
Check the drain hose.
To switch the fault message off:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Blockage detected.
Untangle laundry
and restart
lights
up after a
program has
been cancelled.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Remove a
few items if necessary.
Switch the dryer off and then on again.
Start a program.
Содержание TXR 860 WP
Страница 100: ...M Nr 11 677 050 01 en CA TXR 860 WP ...
