,
There will be a small amount of
residual water in the cap. Take care
as it may be hot from the previous
programme.
^
Screw the salt container firmly onto
the socket.
Run the reactivation programme
^
Close the door.
^
Select and start the
REACTIVATION
programme.
In Operating level
C
reactivation is
started using the context menu. To
do this:
- Open the context menu.
- Select the
REACTIVATION
option
and confirm your selection with
OK
.
The reactivation process will run
automatically.
The water pressure (flow pressure at
the take off point) must be at least
150 kPa.
If it is below 150 kPa or if it
fluctuates a lot, the water softener
will not work properly. There could
be residual salt in the container after
reactivation has taken place.
To use up the remaining salt and to
flush out the softener the
REACTIVATION
process must be
repeated.
Then:
^
Switch the washer disinfector off.
^
Open the door.
^
Carefully unscrew the salt container,
making sure any water pressure still
remaining can depressurise. Do not
use force!
If the container will not come off
manually please contact the Miele
Service Department.
^
Empty the salt container. Do not
empty it into the wash cabinet.
Saline solution and salt granules in
the cabinet can lead to corrosion. It is
important they are flushed out imme-
diately and not left in the cabinet.
^
Replace the cap to the softener unit.
^
Push the mobile unit back into the
cabinet.
^
Rinse the salt container and filter
insert with clean water.
Water softener
27
