Miele KFN 9855 iDE, Инструкции по эксплуатации и монтажу

Страница: 30 / 96

Lower hinge heating control
H
If condensed water appears in the
lower hinge area or on the base plate
between the refrigerator and freezer
compartments, increase the output of
the heating located behind the base
plate.
Factory default is
H A
.
Condensation does not occur at
normal room temperature and
humidity. The heating prevents
condensation at high humidity and
low room temperature.
Changing the heat setting
^
Touch the button for switching Super
Freeze on and off for 5 seconds.
The Super Freeze indicator
ª
to the
right of the display is on during this
time, and after 5 seconds
S
flashes in
the lower temperature display (freezer
section). The display shows MENU. You
are now in the settings mode.
^
Tap the button for setting the
temperature in the freezer section
until a flashing
H
appears in the lower
temperature display.
^
Touch the Super button again.
The following will appear in the display:
–
H A
: select this if there is only little
condensation,
–
H 1
: select this if there is a lot of
condensation,
–
H 0
: select this if there is no
condensation (heating off).
^
Change the heat setting by tapping
the button for setting the temperature
in the freezer section.
^
Touch the Super button again to
confirm your selection.
^
To leave the settings mode, touch the
button for switching the freezer
section on and off.
Additional Settings
30