Installation
*INSTALLATION*
85
A faucet with a 9/16" male thread must
be provided on site. If this type of
faucet is not available, only a qualified
installer may connect the dishwasher to
the domestic water supply.
A backflow preventer is not required.
The appliance meets the requirements
of the applicable DIN standards.
The water connection pressure needs
to be between 50 and 1,000 kPa. If the
water connection pressure is too high, a
pressure reducing valve must be fitted.
Risk of damage from leaking
water.
The connection point is subject to
water pressure. Water leaking from it
can cause damage.
You should therefore open the faucet
slowly and check for leaks. Correct
the position of the seal and screw
thread if appropriate.
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be
operated when it is connected to a
fully primed plumbing system.
Risk of damage from leaking
water.
The water inlet hose is under water
pressure.
The water inlet hose must not be
shortened or damaged in any way.
Risk to health and risk of
damage due to damaged power cord
or water inlet hose
Damage to the power cord or water
inlet hose can lead to electric shocks
or water damage.
Do not place the dishwasher on the
water inlet hose. The water inlet hose
must be free of kinks and able to
move freely after installation. Do not
install the water inlet hose or the
power cord next to a heat source,
such as a hot water pipe. Do not
expose the water inlet hose or the
power cord to corrosive substances
(such as chloride).
Содержание G 7156
