Operation
50
Display of program cycle time
The estimated duration of the selected
program appears on the display before
the program begins. If the door is
opened during the program, the time
left until the end of the program is
displayed.
Each program phase is indicated by a
symbol:
Pre-rinse / Soak
Main wash
Interim rinse
Final rinse
Drying
End
The displayed duration may vary for the
same program. It is influenced by, for
example, the temperature of the
incoming water, the reactivation cycle
of the water softener, the detergent
type, the amount of dishware, and how
soiled it is.
When a program is selected for the first
time, the display will show the average
program cycle time for a cold water
connection.
The program cycle times shown under
“Program overview” refer to standard
test loads and temperatures.
Each time a program is run, the control
module calculates the program cycle
time required depending on the
temperature of the water taken into the
dishwasher and the amount of
dishware.
Starting a program
Start the program by closing the door
within 4 seconds of the last press of a
button.
If necessary, confirm the previously
displayed message with
OK
.
The in-operation indicator light comes
on to show that a program has been
started.
If you do not close the door within
4 seconds, the message
Continue with
OK
will appear in the display.
The program cannot be started until
you confirm the message by
pressing the
OK
button and close the
door within 4 seconds.
During a program sequence, you can
use
OK
to display the name of the
program that is currently running when
the door is open.
Risk of scalding due to hot
water.
During operation, water in the
dishwasher may be very hot.
During operation, only open the door
with extreme caution.
Содержание G 7156
