Technical Information
88
G 600/G 800
6.8.2.3
Service Mode 2
Service Mode 2
is used to determine which upper electronic is in the machine, to
change certain programmed functions and to access fault codes. The programmed
functions include increasing the water temperature, turning on or off the water
softener, adding an interim rinse, and setting the dishwasher width (18” or 24”).
1. To access
Service Mode 2
, close the door and turn the program selector switch
to
Stop
.
2. Turn the dishwasher off.
3. Press and hold the
Start
button while turning the dishwasher on. Release the
Start
button and immediately press it 2 more times. Flashing
Intake/Drain
and
Salt
lights indicates successful accessing of
Service Mode 2
.
4. Turn the program selector switch to the appropriate position in Table 6-10 to
access the various functions of
Service Mode 2
.
Program selector
switch position
Function
Options
Start light status
1 o’clock
Fault codes
See Table 6-11
Flashing
2 o’clock
Program index
See Table 6-12
Flashing
4 o’clock
EGS
On On
Off Off
5 o’clock
Increase temperature
150°F Off
160°F On
6 o’clock
Water softener
With
Off
Without On
7 o’clock
Increase water intake
On On
Off Off
8 o’clock
2 interim rinses
Without
Off
With On
9 o’clock
Extended drying fan
time
Off Off
On On
10 o’clock
Dishwasher width
24”
Off
18” On
Table 6-10:
G 848 Service Mode 2 Functions
6.8.2.3.1
Accessing Fault Codes
1. Access
Service Mode 2
.
2. Turn the program selector switch to the 1 o’clock position.
3. Press
the
Start
button once.
4. If
the
Start
light is lit, no fault has been stored. If the light is not lit, turn the selector switch
slowly clockwise until the
Start
light lights up.
5. Use the fault chart (Table 6-11) to determine which fault has been stored in the
dishwasher.
6. Turn the dishwasher off.
Selector switch position Fault code Fault
1 o’clock
F00
No error
2 o’clock
F01
NTC or NTC connections open-circuited
3 o’clock
F02
NTC or NTC connections short-circuited
4 o’clock
F03
Electronic failure, selector switch position not
found
