Technical Information
137
G 600/G 800
functions include increasing the water temperature, turning on or off the water
softener, adding an interim rinse, and setting the dishwasher width.
1. To
access
Service Mode 2
, open the dishwasher door and turn the dishwasher
off.
2. Press and hold program buttons
2
and
3
while turning the dishwasher on.
Successful accessing of
Service Mode 2
is indicated by flashing
Salt
and
On/Off
lights.
3. The illuminated program button lights will indicate the current program settings
(see Table 6-85).
4. The settings can be changed by using program buttons 1 to 5. To change a
setting, press the corresponding program button as indicated in Table 6-86.
Program button Function
Options
Program light
2
Increase water temperature
150ºF Off
160ºF On
3 Water
softener
With Off
Without On
4
Width of dishwasher
24” Off
18” On
5
Program index
-
Flashing
Fault codes
-
Flashing
Table 6-86:
G 879 Service Mode 2 Functions
6.8.15.3.1 Fault
Code
Access
1. Access
Service Mode 2
.
2. Press the flashing program button
5.
3. Press the flashing program button
1
.
4. One of the program button lights (
1
to
5
) will light up, indicating a stored fault code of F0 -
F4. If none of the program buttons light, a fault code of F5 - F8 is stored. To display fault
codes F5 - F8, press the
Top solo
button once. The
Top solo
button will light, along with
one of the program buttons
1
to
5
. See Table 6-87.
Program button 6
Program button light
Fault code and description
Not pressed
1
F00
No error
Not pressed
2
F01
NTC or NTC connections open-circuited
Not pressed
3
F02
NTC or NTC connections short-circuited
Not pressed
4
F03
Electronic failure, selector switch position not found
Not pressed
5
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
Pressed
1
F05
Water drainage failure, heater level switch
Pressed
2
F06
Too few pulses at flow meter / start of water intake
Pressed
3
F07
Too few pulses at flow meter / end of water intake
Pressed
4
F08
Water intake failure, heater level switch
Table 6-87:
G 879 Fault Codes
6.8.15.3.2 Deleting Stored Fault Codes
1. Access
Service Mode 2
.
2. Press
the
Top solo
button twice.
3. A
flashing
Top solo
light indicates successful deletion of the fault codes.
4. Turn off the dishwasher.
6.8.15.3.3 Program
Index
1. Access
Service Mode 2
.