Miele B 890, Техническая информация

Страница: 17 / 43

Technical Information
17
B 890/B 990
stand and reconnect them to the main electronic.
5. Re-install the main electronic. Do not re-install the electronic's cover.
6. Tilt the ironing table to its horizontal position; see Section 020-4.1.
7. Lay the iron on its back again.
8. Ensure that the Bowden cable is centered on its pulley, taping it in place if
necessary, and then feed the Bowden cable/spring assembly as far down
the stand as possible. Pull the twine or cord through the bottom of the
stand and tie or tape it down.
9. Re-install the base, securing it in place with the four T30 bolts.
10. Grab the J-hook with pliers and reattach it to the base.
11. Check for smooth operation by unlocking the ironing table and moving it
to the stowed (vertical) position; if binding or unusual noises occur,
unhook the spring and check that the Bowden cable is centered on its
pulley.
12. If operation is smooth, re-install the main electronic cover and secure it
with the T20 screw.
Note:
When the cable guide (plastic “neck”) on the cover pushes against the hinge
after reassembly, the cover can break when the iron is folded.
4.5 Bowden Cable Replacement
1. Tilt the ironing table to its horizontal position; see Section 020-4.1.
2. Lay the iron on its back, on a mat or blanket to prevent scratching.
3. Tie a sturdy cord (such as twine) to the J-hook at the bottom of the spring.
4. Release tension from the Bowden cable by disconnecting the tension
spring. Grab the J-hook at the bottom of the spring with pliers and pull it
off of the base to disengage the spring.
Warning!
With the spring disconnected, movement of the ironing table will be
unrestricted because there is no tension holding it in place.
5. Bring the iron to its upright, stowed position (see the operating manual).
6. Place a block of wood or similar between the ironing table and the base to
stabilize the table.
7. Remove the T20 screw securing the Bowden cable holder (Figure 010-5,
Item 1).
8. Carefully press the Bowden cable holder into the table (Figure 010-5,
Item 2).
9. Remove the T20 screw securing the main electronic cover (Figure 010-5,
Item 3).
10. Remove the four T20 screws securing the plastic hinge (Figure 010-5,
Item 4).