Miele B 890, Техническая информация

Страница: 33 / 43

Technical Information
33
B 890/B 990
3 Fault Repair
3.1 Emergency Release Does Not Allow Laundry to Be Removed
Cause:
Leaf spring defective.
Remedy:
Replace the leaf spring with holder; see Section 035-4.1.
3.2 Heater Plate Cannot Be Lowered Completely
Cause:
The emergency release springs open while the iron is in use. The faulty
component here is the catch. When die-cast burrs are removed, the tabs on
the catch are also partially ground down, making them no longer able to hold
the catch in place.
Remedy:
Replace the emergency release catch.
4 Service
4.1 Leaf Spring with Holder Replacement
1. Open the heater plate cover; see Section 020-4.2.
2. Remove the insulation matting; see Section 020-4.3.
3. Release the emergency release (pull the handle upwards).
4. Remove only one of the larger E-clips securing the holder assembly to
the lifting arm (Figure 035-1, Item 1).
5. Remove the washer underneath the E-clip.
6. Slide the hinge pin out of the lifting arm (Figure 035-1, Item 2).
7. Remove the wiring harness retaining clips from the holder (Figure 035-1,
Item 3).
8. Disconnect the ground wire from the holder, if applicable.
9. Remove the holder retaining screws (four T20s) from the heater plate
(Figure 035-1, Item 4).
10. Remove the holder.
11. Install the new holder.
12. Reassemble by following these instructions in reverse order.
Note:
If the emergency release does not allow laundry to be removed, the leaf
spring may need replacement.