Midway CART Fury Championship Racing, Руководство по эксплуатации

Страница: 53 / 104

C.A.R.T. FURY 9
C
HAPTER
3 S
ERVICE
G
ENERAL
D
ASHBOARD
S
ERVICE
To service Steering Assembly…
• Refer to the General Dashboard Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the Dashboard. Refer to service instructions for Dashboard.
• Remove 6 screws used to fasten the cover plate to the center of the steering wheel. Remove the cover
plate and set aside.
• Remove the 3 screws used to fasten the wheel hoop to the shaft. Pull the wheel hoop off of the dash-
board. Disconnect the harness for the buttons on the steering wheel.
• Remove 4 flange nuts holding the motor shield, motor and shaft to the wheel assembly (shield not
required on all cabinets).
• Slide the motor and the shaft off of the assembly.
• Perform the desired repair or equipment replacement.
• Reinstall and fasten all items in place with the screws provided.
While the steering mechanism is exposed, inspect the belt for splits in the rubber or other signs of wear at
the edges of the teeth. Install a new belt if necessary following the instructions below.
To service Steering Belt…
• Loosen four mounting nuts for the motor bracket.
• Tighten the tension-adjust bolt only until there is no belt deflection, then loosen the bolt one full turn and
tighten the four nuts.
• Reattach the mechanism and recalibrate the assembly.
IMPORTANT: Apply removable anaerobic adhesive thread lock (Loctite Blue 242 or equivalent) and
torque set screw to seven to nine ft.-lbs. (84 to 108 in.-lbs.) if it was loosened.
(SEE DETAIL DRAWING)
STEERING MECHANISM
RM-22-38